- 1 Where is ice maker water valve?
- 2 Why does my ice maker not fill with water?
- 3 How long does it take to make ice after replacing inlet valve?
- 4 Can a fridge make ice without a water line?
- 5 How long can a refrigerator water line be?
- 6 Is my saddle valve open or closed?
- 7 What can I use instead of a saddle valve?
Where is ice maker water valve?
Locate your icemaker’s water inlet valve, it is typically located behind a refrigerator. Gently pull your refrigerator away from the wall. You may want to place scraps of carpet, of some other soft material below the fridge to prevent damage to the floor.
Why does my ice maker not fill with water?
Water may not be reaching the ice maker due to a frozen line, missing filter, or a closed supply valve. When there is no filter, or it is clogged, the ice maker does not get water. Make sure that the filter is in place, and if it has not been changed in more than six months, replace it with a new one.
How long does it take to make ice after replacing inlet valve?
It may take up to 24 hours for a newly installed icemaker to start working initially. If you have just added a water line to the refrigerator, it may take up to about an hour and a half for the icemaker to start working. Also, a newly installed water line may have air in the line.
Can a fridge make ice without a water line?
Can a fridge make ice without a water line? You don’t need to hook it up if you don’t want ice and water, the fridge will work fine without it. No, you do not have to install the water line. The ice maker itself doesn’t take up too much space in the freezer, so you could just turn it off and pretend it’s not there.
How long can a refrigerator water line be?
There is no maximum length, you can run the line as long as needed to reach a main water line. You can also use 1/4″ O.D. (outside dimension) copper tubing with a flared end, approximately 8 ft coiled into 3 turns that are 10″ in diameter.
Is my saddle valve open or closed?
When the handle of a ball valve is parallel to the valve or pipe, it’s open. When it’s perpendicular, it’s closed. Saddle valves are self-tapping devices. Once mounted on a line, with the included rubber seal in place, all that is required is to turn the valve clockwise until it pierces the water line.
What can I use instead of a saddle valve?
Tip. A similarly DIY-friendly but more reliable alternative to a saddle valve is a push-fit tee connector designed for ice makers and water dispensers. You install these by cutting out a short section of pipe and installing the tee right into the water line, then you add the small supply line leading to the appliance.