- 1 Can you bend faucet supply line?
- 2 Can water supply lines be bent?
- 3 How tight should water supply lines be?
- 4 Are toilet and faucet supply lines the same?
- 5 How long do braided supply lines last?
- 6 How long should the toilet supply line be?
- 7 Can toilet supply line be too long?
- 8 Should I use Teflon tape on supply lines?
- 9 Can you over tighten water lines?
- 10 Are toilet water supply lines Universal?
Can you bend faucet supply line?
Measure the distance between the water supplies under the sink and then gently bend the soft-copper supply tubes until they’re about the same distance apart as the water supply. They don’t have to be exact, just close. Be very, very careful when shaping the soft copper. You don’t need to be forceful with copper.
Can water supply lines be bent?
Yes, but most plumbers change them.
How tight should water supply lines be?
Hand Tight is Right. In fact, pipes should only be hand tight to help aid the flow of water throughout your home. The unique construction and configuration of pipes means they are made to be tightened just enough; making them super tight can actually prevent water from flowing properly.
Are toilet and faucet supply lines the same?
A faucet, toilet, and refrigerator’s ice maker use a similar water supply line. A toilet connects to the angle stop valve with a 3/8-inch compression fitting, and the toilet’s fill valve accepts a 7/8-inch threaded nut.
How long do braided supply lines last?
How Long To Use Stainless Steel Braided Hoses. Most stainless steel braided hoses last three to five years, according to the manufacturer. It’s important to replace parts after their time has expired even when there’s nothing apparently wrong with them.
How long should the toilet supply line be?
Typically they are 3/8” in diameter, but toilet supply line size can vary in length, usually anywhere from 9” to 20”.
Can toilet supply line be too long?
Ignore the Length The length of the flex line is immaterial. When the shutoff valve on the water pipe is opened to allow water into the line, the water builds up pressure in the flex line regardless of the length. The hot water may be delayed for one or two seconds, but the water pressure will be unaffected.
Should I use Teflon tape on supply lines?
Most faucets will have hot and cold water supply lines attached, so you just need to connect them to the appropriate water supply line. You may need to use Teflon tape (aka plumber’s tape) for this part, which is used to seal and lubricate threaded pipe joints.
Can you over tighten water lines?
Screwing a supply line on too tight is one of the worst things you can do. Such overtightening will cause the metal threads inside of the line to become warped, making it much easier for water to slip past. It may also damage the rubber O-rings inside of the line.
Are toilet water supply lines Universal?
Built to last this universal design fits all common toilets and valves. Size adapters are included with this supply line that fits 3/8 in. Replacing old, or leaking toilet connectors is easy with Fluidmaster’s universal toilet supply lines.