Often asked: What Type Of Water Supply Do You Use For A Water Closet (w.C.)?

What pipe size would be used to supply water to the WC cistern?

The supply line to the toilet is standard 1/2-inch copper or plastic pipe routed from the main water line or a 1/2-inch cold water line.

What is the standard toilet water supply line?

Typically they are 3/8” in diameter, but toilet supply line size can vary in length, usually anywhere from 9” to 20”.

Where does the water in the toilet come from?

Water enters the toilet through a supply line equipped with a shutoff valve, or “closet stop,” at the base of the toilet. After the water travels up the supply line through the base of the tank, it’s diverted in two directions by an inlet-valve assembly sometimes called a ballcock.

What size pipe is used for water lines?

In most cases, the main pipeline from the street to your home is either 3/4 or 1 inch in diameter, supply branches use 3/4-inch-diameter pipe, and pipes for individual components are 1/2 inch. Remember that water pressure decreases by a half-pound per square inch for every foot pipes extend above your water supply.

You might be interested:  Question: Who Voted To Change Flints Water Supply?

Can a toilet drain into a 2 inch pipe?

Unless two toilets are on the same drain and then it must be a 4-inch plumbing waste pipe, the toilet requires a drain pipe of 3 inches in diameter. Unless there is a toilet discharging into the piping, systems with less than nine units can use a 2-inch pipe.

Are toilet water supply lines Universal?

Built to last this universal design fits all common toilets and valves. Size adapters are included with this supply line that fits 3/8 in. Replacing old, or leaking toilet connectors is easy with Fluidmaster’s universal toilet supply lines.

How long do toilet water supply lines last?

A good rule of thumb for replacing supply pipes is: Brass pipes: 80-100 years. Copper pipes: 70-80 years. Galvanized steel pipes: 80-100 years.

How many toilets can be on a 4 inch drain?

It is important to determine the load on the drain pipes and install the pipes of a compatible size. 4″ waste line can support 90 DFU’s, Toilets can be 3–4 DFU’s depending on how many gallons per flush. So, 22 toilets if they use a lot of water.

Are toilet and faucet supply lines the same?

A faucet, toilet, and refrigerator’s ice maker use a similar water supply line. A toilet connects to the angle stop valve with a 3/8-inch compression fitting, and the toilet’s fill valve accepts a 7/8-inch threaded nut.

Can drinking toilet water kill you?

Not at all. The water from your toilet is the same water that’s in the pipes feeding your kitchen sink and ice maker. Albeit the water has touched fairly unsanitary surfaces, like the inside of the toilet tank and resting in the bowl itself, it wouldn’t kill you.

You might be interested:  Readers ask: The Great Lakes Of The United States Contain What Percentage Of The World's Fresh Water Supply?

Does sink water and toilet water go to the same place?

In the US, with modern regulations, in most municipalities, yes, they do. The water and solids from your toilet waste line and the water from your drains end up in the same sewer line, if you have access to a municipal sewer system.

Are toilet and shower drains connected?

Yes, the toilet and shower drain is connected with the main sewerage line pipe. Shower and Toilet Drain is connected with The outside of the main sewerage drain. Basically your toilet & Shower is used to Flow the extra waste-water from your home to the main sewerage line.

Leave a Reply

Your email address will not be published. Required fields are marked *