- 1 Where should a toilet water line be installed?
- 2 What side of toilet is water supply line?
- 3 What size is a toilet connector?
- 4 Can you connect a garden hose to a toilet?
- 5 How high should a toilet supply line be?
- 6 Are toilet and faucet supply lines the same?
- 7 How high should a toilet water line be?
- 8 Do I need Teflon tape on faucet supply lines?
- 9 Can I install a refrigerator without a water line?
- 10 How much does it cost to install a water line for a refrigerator?
- 11 How long do toilet supply lines last?
Where should a toilet water line be installed?
Water Supply Line Install a ½ inch copper water line to the location of your new toilet. Insert the line through the bottom plate on the wall, approximately 8 inches to the left of the toilet’s center line. Connect this supply line at the water line attached to the sink.
What side of toilet is water supply line?
Originally Answered: Can you install the water supply on the right side of the toilet tough in? Yes, but toilets in the US are made to have the inlet on the left. If you put the supply on the right you will need a long and unsightly supply line from the stop valve to the toilet inlet.
What size is a toilet connector?
Typically they are 3/8” in diameter, but toilet supply line size can vary in length, usually anywhere from 9” to 20”. Measure for accuracy to ensure you are buying a part that will match your installation. A flexible line is ideal because its pliability allows you to bend the part as needed.
Can you connect a garden hose to a toilet?
No, no, no. Ballcocks (toilet fill valves) have always had their own thread type. No pipe is ever designed to screw on to the ballcock threads directly. All connections must be some sort of compression, i.e. rigid or flexible toilet supply line or pex adapter fitting.
How high should a toilet supply line be?
Supply Line – One hole positioned between 5 and 10 inches above the finished floor. The supply line should be off-set from the centerline by 5 inches.
Are toilet and faucet supply lines the same?
A faucet, toilet, and refrigerator’s ice maker use a similar water supply line. A toilet connects to the angle stop valve with a 3/8-inch compression fitting, and the toilet’s fill valve accepts a 7/8-inch threaded nut.
How high should a toilet water line be?
#4: Where To Put The Cold Water Supply Line. Needless to say, this usually turns out UGLY. 7 inches above the finished floor allows enough clearance for an escutcheon, and base trim all the way up to 5.25″. A lot of plumbers go 6″ above the finished floor.
Do I need Teflon tape on faucet supply lines?
Most faucets will have hot and cold water supply lines attached, so you just need to connect them to the appropriate water supply line. You may need to use Teflon tape (aka plumber’s tape) for this part, which is used to seal and lubricate threaded pipe joints.
Can I install a refrigerator without a water line?
You don’t need to hook it up if you don’t want ice and water, the fridge will work fine without it. No, you do not have to install the water line. The ice maker itself doesn’t take up too much space in the freezer, so you could just turn it off and pretend it’s not there.
How much does it cost to install a water line for a refrigerator?
Refrigerator Water Line Installation Cost The price to install a water line ranges from $70 to $130.
How long do toilet supply lines last?
A good rule of thumb for replacing supply pipes is: Brass pipes: 80-100 years. Copper pipes: 70-80 years. Galvanized steel pipes: 80-100 years.