- 1 How far off the ground for a supply line to toilet?
- 2 How do you rough in a toilet water line?
- 3 How long do water supply lines last?
- 4 Are toilet and faucet supply lines the same?
- 5 How high off the floor should a toilet valve be?
- 6 How far should a toilet be from the side wall?
- 7 How do I know if my toilet is a 10 or 12 rough?
- 8 What is standard toilet dimensions?
- 9 Should toilet water valve be open all the way?
- 10 Is it bad to shut off water to toilet?
- 11 How do I turn off the water to my bathroom?
How far off the ground for a supply line to toilet?
Supply Line – One hole positioned between 5 and 10 inches above the finished floor. The supply line should be off-set from the centerline by 5 inches.
How do you rough in a toilet water line?
Water Supply Line Install a ½ inch copper water line to the location of your new toilet. Insert the line through the bottom plate on the wall, approximately 8 inches to the left of the toilet’s center line. Connect this supply line at the water line attached to the sink.
How long do water supply lines last?
Here are the expected lifespans for common supply pipes: Copper Pipes: 70-80 years. Brass Pipes: 80-100 years. Galvanized Steel Pipes: 80-100 years.
Are toilet and faucet supply lines the same?
A faucet, toilet, and refrigerator’s ice maker use a similar water supply line. A toilet connects to the angle stop valve with a 3/8-inch compression fitting, and the toilet’s fill valve accepts a 7/8-inch threaded nut.
How high off the floor should a toilet valve be?
With the toilet removed, you can see the toilet flange and measure its height above the floor. Optimum flange height to aim for is 1/4 inch above the finished floor. This typically allows for almost any type of wax ring to be used and still ensure a good seal.
How far should a toilet be from the side wall?
Most codes require at least 15 inches (measured from the center of the toilet) from any side wall or obstruction and not closer than 30 inches center to center to any other sanitary fixture. (The NKBA actually recommends 32 inches.) There should be at least 24 inches of clear space in front of a toilet or bidet.
How do I know if my toilet is a 10 or 12 rough?
To determine the size of your toilet rough-in, measure from the wall behind the toilet to the bolt caps of your current toilet. Most toilets are available in a 12-inch rough-in, which is the standard distance, but a 10- or 14-inch rough-in may be needed in some homes.
What is standard toilet dimensions?
Standard toilet dimensions are typically between 28–30″ deep, roughly 20″ wide, between 27–32″ high, and have a rough-in between 10–14″.
Should toilet water valve be open all the way?
All the way open. The valve controls flow not pressure. Those angle stop valves should be fully open because they have a back seat to prevent leaking in case the stem packing leaks.
Is it bad to shut off water to toilet?
It’s recommended you shut off your water when: A pipe, fixture, or appliance is leaking. The toilet is running constantly even after adjusting the parts in the tank. A pipe bursts.
How do I turn off the water to my bathroom?
Look for a valve with a blue or black handle and turn it a quarter turn to a horizontal position to turn the water off. Turn a knob-style valve counterclockwise until it is hand-tight. Turn on several faucets throughout the house to drain the lines of water and confirm the water shutoff is complete.