Often asked: How To Connect Water Supply To Toilet?

Is the water tank connected to the toilet?

A toilet has two main parts—the tank and the bowl. One of these devices—called a ballcock —is connected to the water supply and controls delivery of water to the tank. When the tank’s water rapidly drops down into the bowl (upon a flush), the pressure causes the bowl’s waste water to go down the drain.

Do all toilet tanks fit all toilets?

Will any tank fit any toilet? Any tank should fit your bowl but you may have to adjust where it hangs on the wall and you may have to cut the supply line to the toilet bowl itself.

How tight should toilet tank bolts be?

Most toilets have a space between the bottom of the tank and the top of the bowl anywhere from a ¼ of an inch to a ½ inch. Tighten too loosely and the tank will leak underneath the rubber washers and down the bolts; tighten too much and risk the tank cracking.

Is toilet water normal water?

In some parts of the world, the wastewater that flows down the drain – yes, including toilet flushes – is now being filtered and treated until it’s as pure as spring water, if not more so. It might not sound appealing, but recycled water is safe and tastes like any other drinking water, bottled or tap.

You might be interested:  Question: How To Bend Copper Water Heater Supply Lines?

Is tap water same as toilet?

The answer is yes. Sink water and toilet water are the same. Their water is being supplied from the same source. Though it may be supplied by different pipes, be rest assured that the water comes from the same source thereby making it the same.

Is shower water toilet water?

TL;DR Answer: Yes. Unless you do grey water collection (mentioned by others), which you would know about, the water that is in your toilet, your sink, and your shower is the same as the water that comes out of a hydrant on the street.

How do I know which toilet tank to buy?

Look for the manufacturer name or a number on the bottom side of the water tank lid. It may be stamped into the lid or painted on – some of them may even be handwritten if the tank lid was replaced by a plumber with foresight.

Can I just replace my toilet tank?

Replacing a toilet tank is a task most homeowners can do without a call to the plumber. Because the tanks and bowls may be sold separately, you can often buy just the tank. However, it is important to match the toilet manufacturer and model to ensure proper installation and function of the toilet when you’re done.

How do I measure for a replacement toilet tank?

A toilet tank’s height is measured from the floor to the top of the toilet tank. Place the end of the tape measure on the floor, and take the measurement at the very top edge of the tank lid. Toilet bowls and seats are either round or oval.

You might be interested:  Readers ask: How To Turn Off Water Supply To Sprinkler System?

Can toilet tank bolts be too tight?

Can Toilet Tank Bolts Be Too Tight? Overtightened toilet tank bolts will crack the toilet tank or the bowl you are attaching it to. This is because toilets are made of porcelain, which is very hard but is prone to cracking. Porcelain won’t bend or flex, so an overtightened bolt will crack the ceramic.

Why is my toilet tank leaning forward?

If you want to work on it – you need to loosen the attachment bolts – re-set the tank a bit more “level” and retighten the bolts. Sounds as if the tank was slightly off center when it was tightened originally. Slipping a shim or two under the front lip will help straighten it up.

Can you over tighten toilet tank?

Do not over tighten or you will crack the tank or bowl even if they are not touching yet. Tighten them until they are good and snug and you can usually see the gaskets on the bolts have compressed some. test it for leaks, if no leaks it is good enough.

Leave a Reply

Your email address will not be published. Required fields are marked *