- 1 How tight should toilet water supply line be?
- 2 Can you over tighten a water supply line?
- 3 Where should water line be on toilet?
- 4 Are toilet water supply lines Universal?
- 5 How much does it cost to tighten a supply line faucet?
- 6 Do you need Teflon tape on sink supply lines?
- 7 How long do toilet supply lines last?
- 8 How do you stop a water supply line from leaking?
- 9 What is a toilet supply line?
- 10 Why does the water in the toilet bowl get low?
- 11 Are toilet and faucet supply lines the same?
How tight should toilet water supply line be?
Normally you should be okay hand tightening it and then giving it an eight to a quarter turn with a good pair of channel locks. Tighten it until it stops leaking, an 1/8th turn at a time.
Can you over tighten a water supply line?
Do not overtighten the supply line. Screwing a supply line on too tight is one of the worst things you can do. Such overtightening will cause the metal threads inside of the line to become warped, making it much easier for water to slip past. It may also damage the rubber O-rings inside of the line.
Where should water line be on toilet?
Most codes require at least 15 inches (measured from the center of the toilet) from any side wall or obstruction and not closer than 30 inches center to center to any other sanitary fixture. (The NKBA actually recommends 32 inches.) There should be at least 24 inches of clear space in front of a toilet or bidet.
Are toilet water supply lines Universal?
Built to last this universal design fits all common toilets and valves. Size adapters are included with this supply line that fits 3/8 in. Replacing old, or leaking toilet connectors is easy with Fluidmaster’s universal toilet supply lines.
How much does it cost to tighten a supply line faucet?
Most directions say to hand tighten then use a wrench for the last 1/4 to 1/2 turn. One of the biggest problems when swapping out water supply lines is knowing how tight the connections should be. Obviously this is important to prevent water leaks.
Do you need Teflon tape on sink supply lines?
Most faucets will have hot and cold water supply lines attached, so you just need to connect them to the appropriate water supply line. You may need to use Teflon tape (aka plumber’s tape) for this part, which is used to seal and lubricate threaded pipe joints.
How long do toilet supply lines last?
A good rule of thumb for replacing supply pipes is: Brass pipes: 80-100 years. Copper pipes: 70-80 years. Galvanized steel pipes: 80-100 years.
How do you stop a water supply line from leaking?
Use a pair of pliers to tighten the fittings enough to stop the leak — hand tightening usually isn’t enough to keep it from leaking. Then once the rubber gasket has had a few hours to compress, tighten it just a little more.
What is a toilet supply line?
Toilet water supply lines carry water from a nearby cold-water supply line to your toilet tank to enable it to flush. Step 1: Measure the distance between your water supply valve (on the wall or floor beneath the toilet) and the point where the line connects to the toilet tank.
Why does the water in the toilet bowl get low?
The most common reason your water level is low is because your fill tube is damaged or broken in some way. This small, flexible plastic hose is the main control of your water level. Or, the toilet bowl may be cracked, causing water to leak onto the bathroom floor.
Are toilet and faucet supply lines the same?
A faucet, toilet, and refrigerator’s ice maker use a similar water supply line. A toilet connects to the angle stop valve with a 3/8-inch compression fitting, and the toilet’s fill valve accepts a 7/8-inch threaded nut.