Often asked: How High From Floor For Toilet Water Supply Valve?

How high should water valves be?

A shower valve and spout should be about 38 to 45 inches above ground. If you also have a bathtub, the valve should be installed 8 to 18 inches above the tub spout.

Can toilet supply line come through floor?

An ordinary toilet can get its supply from the floor — just not from too near the center line. If there is access from below, the pipe could be moved farther from the center.

How high should the toilet water line be?

Supply Line – One hole positioned between 5 and 10 inches above the finished floor. The supply line should be off-set from the centerline by 5 inches.

How high do you mount a shower valve?

A good rule of thumb: for Height of Shower Valve: Install the valve/s between 36 and 48 inches above the shower floor. A height of 28 inches, or 2 feet 4 inches, is standard for valves in bathtub shower units.

Where should toilet supply line be on the floor?

#4: Where To Put The Cold Water Supply Line. Needless to say, this usually turns out UGLY. 7 inches above the finished floor allows enough clearance for an escutcheon, and base trim all the way up to 5.25″. A lot of plumbers go 6″ above the finished floor.

You might be interested:  Often asked: How High On The Wall Is The Water Supply To A Urinal?

Why is my toilet supply line leaking?

A leak can also be because of worn out washers and/or threads. Turn off the water at the shut off valve and remove the hose. Remember, there will be water in the hose so have something like a small Tupperware or bucket to catch it.

What is code for toilet space?

Most codes require at least 15 inches (measured from the center of the toilet) from any side wall or obstruction and not closer than 30 inches center to center to any other sanitary fixture. (The NKBA actually recommends 32 inches.) There should be at least 24 inches of clear space in front of a toilet or bidet.

How do I know if my toilet is a 10 or 12 rough?

To determine the size of your toilet rough-in, measure from the wall behind the toilet to the bolt caps of your current toilet. Most toilets are available in a 12-inch rough-in, which is the standard distance, but a 10- or 14-inch rough-in may be needed in some homes.

Where should shower controls be placed?

Shower controls should be placed 38 inches to 48 inches off the floor, according to NKBA Bathroom Planning Guidelines. Offsetting the controls toward the front of the shower will make them accessible both inside and outside the water spray.

What is standard shower height?

What Is the Standard Shower Head Height? Let’s tackle the most important question right away by pinpointing the standard height for a shower head. According to Hunker, the industry standard for how high a shower head should be is 80 inches. We’re talking 80 inches above the floor of the bathroom.

You might be interested:  FAQ: How To Install Pvc Water Supply Compression Joint?

Does shower head need to be centered?

Nothing says that it needs to be perfectly centered, but many people prefer it to be. Bottom line, it’s your house, your money. Being over towards the doorway a little makes it easier to turn it on and adjust before you enter the shower.

Leave a Reply

Your email address will not be published. Required fields are marked *