- 1 Where should toilet supply line be placed?
- 2 Where do water pipes run in a House UK?
- 3 How high is a sink valve?
- 4 Can toilet supply line come through floor?
- 5 How high should a toilet supply line be off the floor?
- 6 How far should toilet water line be from wall?
- 7 Who is responsible for water pipe from meter to house?
- 8 Who is responsible for water line from street to house UK?
- 9 Where do water pipes run in a house?
- 10 How high should kitchen sink water lines be?
- 11 What’s the standard height for a bathroom sink?
- 12 What is the height of a sink drain pipe?
- 13 Do toilets go on outside walls?
- 14 Why is my toilet supply line leaking?
Where should toilet supply line be placed?
Water Supply Line Install a ½ inch copper water line to the location of your new toilet. Insert the line through the bottom plate on the wall, approximately 8 inches to the left of the toilet’s center line.
Where do water pipes run in a House UK?
Supply systems The most common type of water system in the UK, the indirect system sends fresh water into your property through to the household stopcock valve (main on/off tap)— usually located underneath the kitchen sink.
How high is a sink valve?
Tub Faucet Valves: 20”- 22” above finished floor.
Can toilet supply line come through floor?
An ordinary toilet can get its supply from the floor — just not from too near the center line. If there is access from below, the pipe could be moved farther from the center.
How high should a toilet supply line be off the floor?
Supply Line – One hole positioned between 5 and 10 inches above the finished floor. The supply line should be off-set from the centerline by 5 inches.
How far should toilet water line be from wall?
The Distance To Set The Toilet Flange From The Back Wall. You’ll want to set the center of the water closet flange 12 inches from the finished back wall. Don’t measure from the base molding! Take this measurement from the finished wall.
Who is responsible for water pipe from meter to house?
In most cases, it’s your responsibility to maintain the supply pipe. This is the section of the service pipe from the boundary of your property – usually where the water meter and stop valve are – into the property itself.
Who is responsible for water line from street to house UK?
Supply pipes run from the boundary of the property (where there may be a company stop-tap) up until the first water fitting or stop-tap inside the property. Stop-taps along the length of the supply pipe, and any water fittings, are the property owner’s responsibility to maintain.
Where do water pipes run in a house?
If you have a water plumbing and heating system, such as radiators, you will find the pipes located at the side of the radiator and running behind the wall, or concealed in a baseboard.
How high should kitchen sink water lines be?
The most common kitchen counter height is 36 inches, but it can vary from 30 to 45 inches. The standard kitchen sink is 8 inches deep, which means that the normal distance between a kitchen sink drain and the floor is 28 inches. This will vary, depending on the height of the counter and the depth of the sink bowl.
What’s the standard height for a bathroom sink?
Standard bathroom sink heights range from 29 inches to as much as 36 inches high, depending upon personal preference and the type of sink. For example, pedestal sinks are built between 29 and 33 inches high, while bathroom vanity cabinets with set-in sinks range from 30 to 36 inches in height.
What is the height of a sink drain pipe?
On average, the rough-in height for sink drains is 20” above the floor. Kitchen sink drains may have a height of 30” as they sit taller than say, bathroom sinks which have an average height of 18” to 20”.
Do toilets go on outside walls?
Toilets should have a minimum of 15 inches from walls that flank the fixture. A distance of 12 to 12.5 inches should be between the center of the toilet flange and the back wall. Before installing a toilet, ensure that you look up local building codes and start measurements for fixtures.
Why is my toilet supply line leaking?
A leak can also be because of worn out washers and/or threads. Turn off the water at the shut off valve and remove the hose. Remember, there will be water in the hose so have something like a small Tupperware or bucket to catch it.